Subscribe to Our Youtube Channel
Related Manuals for HIKOKI NT 1865DMA
Summary of Contents for HIKOKI NT 1865DMA
- Page 1 NT 1865DMA・NT 1865DM・NT 1850DE NT 1865DMA NT 1865DM NT 1850DE Handling instructions...
-
Page 2: General Power Tool Safety Warnings
power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on. -
Page 3: Additional Safety Warnings
c) When battery pack is not in use, keep it away eye is a threat to sight. Eye protection can be bought at from other metal objects, like paper clips, coins, any hardware store. Always wear eye protection while keys, nails, screws or other small metal objects, operating this tool. - Page 4 15. Beware of the tool’s kickback. 24. Always charge battery ambient Do not approach the top of the tool with your head etc. temperature of 0–40°C. during operation. This is dangerous because the tool A temperature of less than 0°C will result in over charging may recoil violently if the nail currently being driven in which is dangerous.
-
Page 5: Caution On Lithium-Ion Battery
3. If you fi nd rust, foul odor, overheating, discolor, CAUTION ON LITHIUM-ION BATTERY deformation, and/or other irregularities when using the battery for the fi rst time, do not use and return it to your To extend the lifetime, the lithium-ion battery equips with the supplier or vendor. - Page 6 Battery indicator:1 LED (Red) lights The battery remaining power is nearly empty. Recharge the battery as soon as possible. NT 1865DMA : Cordless Finish Nailer Battery indicator:1 LED (Red) blink NT 1865DM : Cordless Finish Nailer Contact HiKOKI for inspection.
-
Page 7: Specifications
Depending on attached battery. The heaviest weight is measured with BSL36B18 (sold separately). 3. Battery Charger Model UC18YFSL Charging voltage DC 14.4 – 18 V Weight 0.5 kg NOTE Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice. -
Page 8: Nail Selection
NAIL SELECTION Only nails shown in the Table below can be driven with this Nailer. Dimensions of nails <NT1865DMA> Min. Max. 2.4 mm 15 Gauge fi nish nails (Angle: 34°) 34° 1.8 mm <NT1865DM> Min. Max. 2.8 mm 16 Gauge fi nish nails (straight) 1.4 mm 1.65 mm... -
Page 9: Standard Accessories
<NT1850DE> Max. 18 Gauge brad nails 1.9 mm (straight) 1 mm 1.25 mm STANDARD ACCESSORIES CHARGING In addition to the main unit (1 unit), the package contains the Before using the power tool, charge the battery as follows. accessories listed on page 17. 1. -
Page 10: Before Use
Table 3 Charging time (At 20°C) again after 30 seconds or so. If this does not cause the pilot lamp to blink in red (every second), please take the Charger charger to the HiKOKI Authorized Service Center. UC18YFSL Battery BEFORE USE BSL1830C Approx. - Page 11 If abnormal operation occurs, stop using the Nailer and Allow the nailer to cool contact a HiKOKI authorized service center immediately. or warm-up thoroughly in (1) REMOVE ALL NAILS AND BATTERY FROM NAILER. adequate condition. □ ALL SCREWS MUST BE TIGHTENED.
- Page 12 ○ Before starting work, check the nailing operation When loading nails into Nailer, switching device. 1) remove battery from the nailer; This HiKOKI nailer includes a nailing operation switching 2) do not pull trigger; device. 3) do not depress push lever; and Before starting work, make sure that the switching 4) keep nailer pointed downward.
- Page 13 ○ Keep hands and body away from the discharge area. There are two methods of operation to drive nails with This HiKOKI nailer may bounce from the recoil of driving this Nailer. a nail and unwanted subsequent nail may be driven, They are: possibly causing injury.
-
Page 14: Maintenance And Inspection
To assure that each nail penetrates to the same depth, NOTE be sure that the Nailer is always held fi rmly against the In case of frequent jam, contact a HiKOKI authorized workpiece. service center. If nails are driven too deep or shallow into the workpiece, adjust the nailing in the following order. - Page 15 The declared vibration total value has been measured in Important notice on the batteries for the HiKOKI accordance with a standard test method and may be used cordless power tools for comparing one tool with another. Please always use one of our designated genuine It may also be used in a preliminary assessment of exposure.
-
Page 16: Troubleshooting
TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. PROBLEM CHECK METHOD CORRECTION Power switch doesn’t turn Low battery charge. - Page 17 NT1865DMA NT1865DM NT1850DE (NN) (NN) (NNP) (NN) ― ― ― ― BSL1830C ― ― ― ― UC18YFSL ― ― ― ― ― ― ― ― ― ― ― ― ― ―...
- Page 18 <NT1865DMA> <NT1865DM> <NT1850DE>...
- Page 19 < > UC18YFSL...
- Page 20 < > NT1865DMA / NT1865DM < > < > NT1865DMA / NT1865DM NT1865DMA / NT1865DM < > < > NT1865DMA / NT1865DM NT1865DMA / NT1865DM...
- Page 21 < > < > NT1850DE NT1850DE < > NT1850DE...
- Page 22 < > < > NT1865DMA NT1865DM...
- Page 23 < > NT1850DE...
- Page 24 BSL36..18 BSL18.. UC18YFSL (14.4V - 18V) 329897 337528...
- Page 25 English Português GUARANTEE CERTIFICATE CERTIFICADO DE GARANTIA Model No. Número do modelo Serial No. Número do série Date of Purchase Data de compra Customer Name and Address Nome e morada do cliente Dealer Name and Address Nome e morada do distribuidor (Please stamp dealer name and address) (Por favor, carímbe o nome e morada do distribuidor) Deutsch...
- Page 27 Hikoki Power Tools Deutschland GmbH Hikoki Power Tools Norway AS Siemensring 34, 47877 willich, Germany Kjeller Vest 7, N-2007 Kjeller, Norway Tel: +49 2154 49930 Tel: (+47) 6692 6600 Fax: +49 2154 499350 Fax: (+47) 6692 6650 URL: http://www.hikoki-powertools.de URL: http://www.hikoki-powertools.no Hikoki Power Tools Netherlands B.V.
- Page 28 EN60745-2-16:2010 EN60335-1:2012+A11:2014 EN60335-2-29:2004+A2:2010 EN55014-1:2006+A1:2009+A2:2011 EN55014-2:1997+A1:2001+A2:2008 Representative offi ce in Europe 31. 3. 2021 Hikoki Power Tools Deutschland GmbH Akihisa Yahagi European Standard Manager Siemensring 34, 47877 Willich, Germany 31. 3. 2021 Head offi ce in Japan Koki Holdings Co., Ltd.
Need help?
Do you have a question about the NT 1865DMA and is the answer not in the manual?
Questions and answers