Electrolux EFCR 90441 User Manual page 21

Connection to an exter Connection to an exter
Connection to an external motor Connection to an exter Connection to an exter
Only for models EFCR 90441
The hood is not equipped with an
internal motor and must be connected
to an external motor (to purchase
separately).
The electrical connection must be
made with the help of suitable
attachments.
Attention! Only use an exter Attention! Only use an exter Attention! Only use an external motor
Attention! Only use an exter Attention! Only use an exter
supplied by the constructor. . . . . supplied by the constructor supplied by the constructor
supplied by the constructor supplied by the constructor
Connecting the discharge tube to Connecting the discharge tube to Connecting the discharge tube to
Connecting the discharge tube to Connecting the discharge tube to
the exter the external the exter nal nal nal motor motor motor motor. . . . .
the exter the exter nal motor
The external motor must be installed in
a reasonably spacious point, respecting
the regulations in force.
The external motor must be connected
to the hood with a discharge tube
having an adequate diameter (min. 150
mm).
Note that the longer the discharge tube
is, the less effective will be the suction
effect. The length of the discharge tube
must not be more than 7 metres in any
case.
All the materials needed for connecting
the hood to the external motor (tubes,
electrical cables, etc.) are not supplied
and must be purchased separately.
nal motor nal motor Electrical connection of the Electrical connection of the
nal motor nal motor Electrical connection of the Electrical connection of the Electrical connection of the
exter exter
exter external motor exter
• Check the position of branching box
• Remove the S S S S S screws and open the
• Open the cable holder and remove
• Use a (3x0.75) type cable to connect
• Connect the clamps of the motor
nal motor nal motor nal motor
nal motor
• Close the cable holder with the L L L L L
• Close cover B B B B B and fix the S S S S S screws.
• Connect the hood to the power
Electrical cable Electrical cable Electrical cable Electrical cable Electrical cable
H05 VVF (3x0.75) H05 VVF (3x0.75) H05 VVF (3x0.75) H05 VVF (3x0.75) H05 VVF (3x0.75)
electrolux electrolux electrolux electrolux electrolux installation
nal motor nal motor
nal motor nal motor
B B B B B positioned over the hood.
cover of box B B B B B .
the L L L L L screws.
the hood.
cable on the terminal board in
branching box B to the hood.
screws.
supply.
Exter External motor Exter nal motor nal motor nal motor (for external installation)
Exter Exter nal motor
942 122 035
Exter Exter External motor Exter Exter nal motor nal motor nal motor nal motor (for internal installation)
942 122 036
T T T T T ube ube ube
ube ube
21 21 21 21 21
GB
B
S
L
N