Electrolux EFCR 90441 User Manual page 10

10 10 electr electr olux olux
10 10 10 electr electr electrolux olux control panel olux
Gr Grease and char Gr ease and char ease and charcoal filter ease and char
Gr Gr ease and char
maintenance indicator maintenance indicator maintenance indicator maintenance indicator maintenance indicator
GB
This hood is fitted with a device that
indicates when it is necessary to clean
the grease filter or the charcoal filter (if
the hood is used in the recirculation
version with a charcoal filter).
On delivery, the hood is not supplied
with a charcoal filter, so the saturation
indicator will be disabled.
If the hood is to be used with a
charcoal filter, the saturation
indicator light must be enabled as
follows:
OFF OFF
Set in "OFF OFF OFF" the hood.
Press buttons 1 1 1 1 1 and 3 3 3 3 3 simultaneously
and hold them for 3 seconds. At first
only the grease filter LED F F F F F will light up,
but when the charcoal filter LED C C C C C
lights up the saturation indicator will be
enabled.
To disable it: Press buttons 1 1 1 1 1 and 3 3 3 3 3
again simultaneously and hold
them for 3 seconds, until the charcoal
filter LED C C C C C goes out.
coal filter coal filter coal filter
coal filter
Grease filter LED
LED F F F F F will start to flash when it is time
to clean the grease filter.
Cleaning will be necessary after 40
working hours. Always comply with the
maintenance instructions for the grease
filter.
Charcoal filter LED
The charcoal filter LED C C C C C will start to
flash when the charcoal filter needs to
be replaced.
This operation is necessary after
approximately 160 working hours.
Resetting the saturation indicator
After cleaning or replacing the filters,
press button 3 3 3 3 3 for 3 seconds until the
grease filter LED F F F F F or the charcoal filter
LED C C C C C stops flashing.