Configuration; Configuration Via Button - WAGO 787-3861/800-000 Product Manual

787-3861/800-000

9 Configuration

9.1 Configuration via Button

The button can be used to configure signal output S2:
1. Switch off the channel.
ð The status LED lights up red.
2. Press and hold the button for at least 3 seconds.
ð You are in configuration mode.
ð The status LED lights up red and flashes green cyclically (according to the follow-
3. Press the button once.
The status LED lights up red and flashes green cyclically (according to the following
table).
ð You are in the next configuration status.
4. To save the selected configuration status, press and hold the button for at least
3 seconds.
The configuration status is saved.
The status LED lights up red
If the button is not pressed in configuration mode for > 30 seconds, the configuration is
discarded, and the last saved configuration status is retained.
Product manual | Version: 1.0.0
Electronic Circuit Breaker
ing table).
Configuration
31