ZyXEL Communications Prestige P660RU-T1 Firmware Release Notes page 9

ZyXEL Confidential
Symptom: A problem about can't get ip(enet encap/llc/dynamic)
Condition: 1. Use"sys romreset"in SMT 24.8
2. Go to WEB wizard or SMT 4, use enet encap/LLC/dynamic ip, set the
vpi/vci=0/33, then the device can't get ip (use other vpi/vci is ok, our AUT-C set vpi/vci is
0/33).
3. [BUG FIX] SPRID: 050516864
Symptom: Use ax/4000 test UBR have problem
Condition: Set menu 4 ATM QoS Type= UBR, Peak Cell Rate (PCR) = 1000, Sustain
Cell Rate (SCR) = 500, Maximum Burst Size (MBS) =500, The traffic do not restrict by
the PCR, it can up to 1600 cells/s.
4. [FEATURE ENHENCE]
Routing Throughput Enhancement.
5. Change Default Rom-file
Add new rule into VC hunting table: VPI/VCI: 0/38 Encapsulation: PPPOA
Multiplexing: VC
Modification in V3.40(ST.3)b1 | 05/19/2005
1. [Bug Fix] SPRID: 050505225
Symptom: While use "Full Feature" mode in NAT in GUI, and configure rule in "Full
Feature", but this NAT rule can not work. Then reboot DUT, this rule can works
properly.
Condition: Step1: In GUI/Advanced Setup/NAT, choose "Full Feature".
Step2: In "Full Feature", configure a NAT rule (For example: One-to-One,
or Many-to-One......).
Step3: While complete the setting, this NAT "Full Feature" rule can not
work. Then reboot DUT, this rule can works properly.
Step4: In SMT, it has no this issue.
2. [Bug Fix] SPRID: 050506301
Symptom: use pppoe encapsulation， get rom-t file from LAN pc change some
configuration and put the rom-t file, then pppoe login password will be change.
Condition: step1: use pppoe encapsulation, get rom-t file from LAN pc change some
configuration(such as system name->1234)
step2: put rom-t file from LAN pc ,after the DUT reboot, pppoe can not dial
up.
step3: change the pppoe login password then can dial up.
3. [Bug Fix] SPRID: 050310555
Symptom: in eWC can set DUT LAN ip to 0.0.0.0, in SMT menu3.2 when set it, it
warning "0.0.0.0 is not a valid IP address" they are not match.
Condition: N/A
4. [Bug Fix] SPRID: 050310549
Symptom: When 2 PCs visit eWC of DUT, the priority have some problem .
Condition: N/A
5. [Bug Fix] SPRID: 041222143
Symptom: in menu 24.11, leave the telnet server port default, upload firmware using
tftp from lan side pc, it always fails; but if telnet server port is changed to 23, the
function works well.
340ST5C0.doc
9/25