ZyXEL Communications P-660R-T3 V2 Release Note page 6

ZyXEL Confidential
Default gateway: 192.168.1.1
5 Wan status
P-660R-T3_v2> wan node index 1
P-660R-T3_v2> wan node disp
WAN node index = 1
Active = yes
Route IP = on
Bridge = off
Name = MyISP
Encapsulcation <2:PPPoE|3:RFC1483|4:PPPoA|5:Enet Encap> = 5
Mux <1:LLC|2:VC> = 1
VPI/VCI = 8 / 35
PPPoE service name =
PPP username = user
PPP password = 1234
PPP authentication <1:PAP|2:CHAP|3:BOTH> = 3
SUA/NAT is enabled, NAT lookupset = 255
Dynamic IP address
WAN IP address
Remote IP address
Remote IP subnet mask = 0.0.0.0
Idle timeout = 0
Call scheduling set = 0 0 0 0
Nailed-up connection = off
QOS Type <2:CBR|3:UBR|4:VBR_nRT|5:VBR_RT> = 3
QOS PCR/SCR/MBS =
RIP direction <0:none|1:both|2:in|3:out>= 0
RIP version <0:RIP-1|1:RIP-2B|2:RIP-2M> = 0
Multicast <0:IGMP-v2|1:IGMP-v1|2:none> = 2
Incoming protocol filter set = 0 0 0 0
Incoming device filter set
Outgoing protocol filter set = 0 0 0 0
Outgoing device filter set
Call protocol filter set = 0 0 0 0
Call device filter set = 0 0 0 0
6 Vc-autohunt table
P-660R-T3_v2> wan atm vc disp
(1) Configure Buffer
(2) RemoteNode (Read Only)
RN VPI VCI | RN VPI VCI | RN VPI VCI | RN VPI VCI |
---------------------------------------------------------------
1 8 35 | 2 0 0 | 3 0
5 0 0 | 6 0 0 | 7 0
(3) VC Hunt Table: (User setting)
Flags: Active(1)
RN VPI VCI serv| RN VPI VCI serv| RN VPI VCI serv| RN VPI VCI serv
= 0.0.0.0
= 0.0.0.0
0, 0, 0
= 0 0 0 0
= 0 0 0 0
0 | 4 0 0 |
0 | 8 0 0 |
6/16