ECO2 Systems SANCO2 GS5-45HPC-D Installation Manual page 25

Heat pump water heater with natural refrigerant(co2)
Hide thumbs Also See for SANCO2 GS5-45HPC-D:
Table of Contents

Advertisement

No.00
No.01
No.02
No.03
No.04
No.05
No.06
No.07
No.00
Tank TH A temp
No.08
No.04
Outlet water temp
No.09
No.10
No.05
Inlet water temp
No.11
No.07
Ambient temp
No.012〜99
To bypass the Parameter Display, simply press the UP key to return the first option mode
in the Commissioning menu
To Exit Commissioning Mode, do not press any key for 60 seconds and Control will default
to sleep mode and revert to the current time display when awoken.
Air Bleeding Mode
Enter into Commissioning Mode
First option is the Heat Setting
Second option is Block Out Time
Third option is Communication Setting
Fourth option is Modbus ID Setting
Fifth option is Error history
Sixth option is Parameter -
Press the UP Key to access Air bleeding Mode then Enter to access
In this mode pump will run for 5 minutes to bleed air from the piping.
To bypass the Air Bleeding Mode, simply press the UP key to return the first option mode in the
Commissioning menu
To Exit Commissioning Mode, hold Enter Key or do not press any key for 60 seconds and
Control will default to sleep mode and revert to the current time display when awoken.
Tank TH temp
Outlet water temp
Inlet water temp
Factory Default Value
Factory Default Value
Factory Default Value
Ambient temp
Factory Default Value
Factory Default Value
Factory Default Value
Factory Default Value
Factory Default Value
Empty
SANCO
Heat Pump – Installation Manual
2
Page 25 of 44
access the next parameter

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SANCO2 GS5-45HPC-D and is the answer not in the manual?

Table of Contents

Save PDF