Advertisement
@ PROGRAMMING mode-select buttons:
(TAPE EDIT/MANUAL/RANDOM)
@ TAPE EDIT (tape-programming mode-select button):
In addition, automatic tape programming is also possible by then once
again pressing this button.
(Refer to "TRACK PROGRAMMING".)
This button can be used to select the desired time display (elapsed play
time for the track now playing, or remaining play time for the track now
@® INTRO
SCAN
play button (INTRO SCAN)
® STOP button (STOP)
When this button is pressed, the disc stops. When the PLAY button is
next pressed, play will resume from the beginning of the disc (during
ordinary play) or from the beginning of the first programmed track (during
programmed play).
@
PAUSE
button
(PAUSE)
When
this button is pressed during play, the " D> " indicator flashes
continuously and disc play is stopped temporarily (without returning to the
beginning of the disc). To resume play, press this button again, or the
PLAY button; play will begin again from where stopped.
@® PLAY button (PLAY)
Press this button to begin play. The " p> " indicator will illuminate.
@
OPEN/CLOSE
button
(OPEN/CLOSE)
The disc tray can be opened and closed by pressing this button.
@ Numeric buttons (+10 and 1 - 0)
These buttons are used when selecting the track number(s),
either for
ordinary play or for programmed
play (including programmed
play for
recording to tapes). These buttons are also used to input the total
available time for recording (on a tape to be used for programmed
tape
recording from a disc).
For a track higher than "9", first press the "+ 10" button (once for "10" to
"149" twice for "20" and higher, etc.) and then press the appropriate
button for the second
digit.
@® POWER switch (POWER)
Press this switch once to switch ON the power;
press it again to switch
OFF the power.
l
Advertisement
