RECORDING TO TAPE)".
2, Press the "RANDOM"
button so that the unit will memorize the total
recording tirne available on the tape.
PLAY button on this unit.
Notes:
CHECKING,
CORRECTING
AND CANCELING
OF
PROGRAMMED
SETTINGS
To check the programmed settings
1. Press the STOP
button.
2. Then press the button corresponding to the settings you want to
check:
|
* Press the PROGRAMMING
mode-select button marked "MANUAL" to
check the settings for the manual-programming
mode
or of the
manual tape-programming mode.
*
Press the PROGRAMMING
mode-select
button marked
"TAPE EDIT"
to check the settings of the automatic tape-programming
mode.
* Press the PROGRAMMING
mode-select button marked "RANDOM" to
check the settings of the random-sequential-tape-programming
mode.
3. Each time the SKIP D
button is then pressed, the track numbers
and sequential order of the programmed tracks can be checked one
after another.
To correct a programmed seiting
1. Follow steps 1 to 3 above.
2. Wherever necessary, press a numeric button to select a track to
replace one you want to replace. The previously programmed
track will
be cleared (from the memory) and the new one will be programmed.
ə Random-sequential-programmed
settings and automatic tape-
programmed settings cannot be corrected.
To cancel a programmed setting
There are several methods, as described below.
è Press the OPEN/CLOSE
button while pressing the STOP button.
|
@ Open the disc tray.
17