Advertisement
If the unit fails to operate normally, check the following points to determine whether the problem can be corrected by the simple measures suggested. If it cannot, or if the problem is not listed in
the SYMPTOM
column, disconnect the unit's power cord and contact your dealer or service center for assistance.
_
switch is pressed.
The disc tray cloes not close completely.
The DISC
indicator does not illuminate.
Play does not begin.
Play is delayed, or begins at the wrong place.
No sound.
The player does not switch
ON when the POWER
The power cord is not connected or not completely connected.
Securely connect the power cord.
A foreign object is obstructing the tray.
Carefully check the disc tray and remove
the foreign object.
The disc has been loaded upside down.
Load the disc correctly.
The disc is damaged.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after 'switching the unit ON before trying
to play a disc.
The disc has been loaded upside down.
Reload the disc with the label side up.
The disc is dirty.
.
Clean the disc.
There is moisture on the laser pickup.
Check the disc carefully; replace it if necessary.
Connect the cables properly. If the problem persists, the cables
may be defective.
The disc may be scratched or damaged.
improper output cable connections.
Improper amplifier operation.
Set the amplifier controls to the correct input selection.
Sound "skips".
Sound
"hums".
Noise from a nearby tuner.
Noise from within the disc tray.
The player is being subjected to vibrations or impacts.
Relocate the player.
'The disc is dirty.
Clean the disc.
Improper cable connections.
The tuner is too close to the player.
.
Move the tuner and player farther apart.
The disc may be warped.
Replace the disc.
Securely connect the audio cables. If the problem persists, the
cables may be defective.
19
Advertisement
