Advertisement
(See Fig. EI.)
® Before making any connections, switch OFF the power to the unit and
the amplifier or other component.
re
Connect either the LINE OUT analog output terminals, or the DIGITAL
OUT terminal, to the amplifier to be used.
@ Be sure that the connection from the left ("L") LINE OUT analog output
terminal and from the right ("R") terminal are to the correct
corresponding (left and right) terminals of the amplifier or other
component.
;
® Connections should be made to the correct input terminals of the
amplifier or other component.
Refer to that component's operation
manual for details.
e |f the placement of this unit causes
noise from other equipment, such
as a tuner, use them farther away from each other.
When the LINE OUT (analog) terminals of this unit are used
e Make the connections from these terminals to the "CD"
(or "AUX")
terminals of the amplifier. If it does not have such terminals, use the
"TAPE PB" terminals. For additional details concerning these
connections, refer to the operation instructions for the amplifier being
used.
fre The HI-BIT DIRECT OUT switch of this unit can be used to select
either direct (unfiltered) analog output signals or filtered analog signals ©
from this unit. When the HI-BIT DIRECT OUT switch is set to ON
(pressed in), the output from the LINE OUT terminals is analog signals
that have passed through the 8-fold oversampling digital filter and the
Hi-Bit converter system. When the HI-BIT DIRECT OUT switch is set to
OFF, the output from the LINE OUT terminals is analog signals that
have passed through an additional analog low-pass filter.
s When the DIGITAL OUT terminal of this unit is used
@ Make the connection from this terminal to the digital input terminal of
an amplifier or D/A (digital-to-analog) converter by using the included
connection cord.
. Press the POWER switch to switch ON the power.
. Press the OPEN/CLOSE button to open the disc tray.
3. Place a compact disc in the round recessed
area of the disc tray, with
the label facing upward.
Be sure the disc is positioned correctly.
The 3-inch (8-cm) type of compact disc should be placed in the
smaller, inner recessed area of the disc tray.
. Close the disc tray (by pressing the OPEN/CLOSE
button, or by
pressing the PLAY button, or by pressing the front edge of the disc
tray gently, or by pressing a numeric button).
* If the disc tray is closed by pressing the front edge of the disc tray,
or by pressing the PLAY button, or by pressing a numeric button, it
is not necessary to press the PLAY button again; play will begin
automatically.
11
Advertisement
