Safety Symbols - Stanley DUBUIS BCP045G User Manual

Safety symbols and signal words, as shown below, are used to emphasize all operator, maintenance and repair
actions which, if not strictly followed, could result in a life-threatening situation, bodily injury or damage to equipment.
IP44
Always observe safety symbols. They are included for your safety and for the protection of the tool.
LOCAL SAFETY REGULATIONS
Enter any local safety regulations here. Keep these instructions in an area accessible to the operator and maintenance
personnel.
6 ► BCP045G User Manual

SAFETY SYMBOLS

Refer to user manual.
Wear eye protection.
Wear safety footwear.
Wear protective gloves.
This is the safety alert symbol. It is used to alert you to potential personal injury
hazards. Obey all safety messages that follow this symbol to avoid possible
injury or death.
KEEP HANDS CLEAR OF THE MOVING PARTS.
Please, do not put your fingers between blades. Risk of grave cuts.
Handle the locking spindle with precaution to avoid being pinched.
CHECK THAT THE LOCKING PIN IS CLOSED CORRECTLY BEFORE
CUTTING.
DO NOT CUT LIVE CABLES
Front lighting greater than 500 lux at 200mm
Protected against solid bodies larger than 1mm.
Protected against low-pressure water jets from all directions.
This safety alert and signal word indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
This safety alert and signal word indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
This safety alert and signal word indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
This signal word indicates a potentially hazardous situation which, if not avoided,
may result in property damage.
This signal word indicates a situation which, if not avoided, will result in damage
to the equipment.
This signal word indicates a situation which, if not avoided, may result in damage
to the equipment.