Cutting Blade - Klutch 114832 Owner's Manual

A cutting blade may burst and cause injury to the operator.
•
The cutting blade manufacturer issues warnings and recommendations for the use and proper care
•
of the cutting blade. Those warnings come with the cutting blade. Read and follow all instructions
from the cutting blade manufacturer.
A cutting blade should be checked before it is assembled on the saw and frequently during use.
•
Look for cracks, lost segments (diamond blades) or pieces broken off. Do not use a damaged cutting
blade.
Test the integrity of each new cutting blade by running it at full throttle for about 1 minute.
•
Cutting blades are available in two basic designs, abrasive blades and diamond blades
High-quality blades a「e often most economical. Lower quality blades often have inferior cutting
capacity and a shorter service life, which results in a higher cost in relation to the quantity of material
that is cut.
Make sure that the right bushing is used for the cutting blade to be fitted on the machine. See the
instructions under the heading Fitting the cutting blade
Suitable cutting blades

Cutting Blade

Abrasive blades
Diamond blades
Toothed blades
Cutting blades for different materials
Follow the instructions supplied with the cutting blade concerning the suitability of the blade for
various applications, or consult your dealer in case of doubts
Abrasive blades
Diamond blades
Hand held, high speed machines
Many cutting blades that might fit this power cutter are intended for stationary saws and

have a lower speed rating than is needed for this hand-held saw. Cutting blades with a lower
speed rating shall never be used on this saw.
Check that the blade is approved for the same or higher speed according to the approval

plate of the engine. Never use a cutting blade with a lower speed rating than that of the
Cutting Blade
⚠WARNING
Yes
Yes
Yes
Concrete Metal
Yes
Yes
Page 11 of 40
Plastic
Yes Yes
Yes
Cast Iron
Yes
Yes