AT Command Set and S-Registers
Table 4-1. AT Command Reference (6 of 18)
AT
Command Description
X n
Extended
Response Codes
(continued)
X0 Disabled
(CONNECT)
X1 Enabled
(CONNECT line rate)
X2 Enabled
(CONNECT line rate)
X3 Enabled
(CONNECT line rate)
X4 Enabled
(CONNECT line rate)
X5 Enabled
(CONNECT line rate/REL)
X6 Enabled
(CONNECT line rate protocol)
X7 Enabled
(CONNECT dte rate)
Z n
RESET AND LOAD STORED PROFILE
This command causes the modem to go on-hook (hang-up),
performs a warm reset, and then load a User Profile (which
has been previously stored in the modem's memory) into the
Active Profile. This command is last in a command string
because all subsequent commands are ignored.
Z0
Z1
Resets the modem and loads User Profile 0 options
into the Active profile.
Resets the modem and loads User Profile 1 options
into the Active profile.
Dial Tone
Busy Tone
Detect
Detect
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
Disabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Issue 2
May 1995
4-7