Table of Contents
Advertisement
Index
B
backspace character (S5), 4-20
blind dial pause time (S6), 4-21
blind dialing, 4-6
break signal control (\K), 4-9
bulletin board system, 1-5
busy tone detection (X), 4-6, C-3
C
carriage return character (S3),
4-20
CD control (&C), 4-12
Cellular Direct Connect Cable,
1-4, D-1
cellular operation
Automatic Cellular Setup, D-3
direct connect, D-1
DTMF tone timer, 4-22
ETC, 1-2, D-3
interference, D-8
checksum of firmware (I2), 4-4
COM port, 2-4, 2-5, A-2, A-3
comma as a pause time dial
modifier, 4-3
command character echo (E), 4-4
command mode, 3-2, 3-3, 3-9
command strings, 3-4, 3-5
communications software, 1-4
D
data character format, 3-4
data compression, 4-10, 4-19, E-3
data mode, 3-2, 3-9
data mode, return to (O), 4-4
IN-2
Issue 2
May 1995
data rate selection (%B), 4-18
data rates, B-1
destructive mode, 4-9
diagnostic program, A-1
dial modifiers, 3-5, 4-3
dial pulse ratio (&P), 4-14
dial tone detection (X), 4-6, C-3
direct mode (\N1), 4-10, A-7
displaying telephone directory
(&V), 4-16
download, 3-14
DSR control (&S), 4-14
DTE speed, 4-24
DTMF tone timer (S11), 4-22
DTR, 3-8, 3-9
disconnect, 3-8
signal control (&D), 4-12
signal detection (S25), 4-22
E
echo of commands (E), 4-4
equipment
cellular operation, 1-4
required, 1-4
supplied, 1-3
error control, 4-8, E-3
error control fallback character
(%A), 4-17
error control modes (\N), 4-10
escape guard time, 3-9, 4-22
escape sequence (+++), 3-2, 3-9,
4-2
escape sequence character (S2),
4-20
examples of dial command strings,
3-7
expedited mode, 4-9
extended response codes (X), 4-6
Advertisement
Table of Contents
