F6 Cellular Setup For Connection On The Pstn Side - Paradyne KeepInTouch 3760 User Manual

Table D-2. &F5 Cellular Setup Configuration
Parameters (2 of 2)
Configuration Option
Cellular Enhancements Enable
Transmit Level
(in North America only)
No Answer Time-out
V.32 bis Train
NOTE:
In North America, some of the hardware components of
your cellular telephone setup, such as the RJ11 adapter
box, may require you to make adjustments to your
modem's dial transmit level (&I command).
If you are using a Spectrum Cellular AXCELL
issue the &I10 (–10 dBm) command after the &F5
command to adjust the modem's dial transmit level. For
example:
TYPE: AT&F5&I10&W
PRESS: Enter
&F6 Cellular Setup for
Connection on the PSTN Side
If your modem connects directly to normal land lines, but
communicates to a remote modem that may be attached to
either a cellular telephone or normal telephone line, configure
the modem using the &F6 command. This command restores
the modem to its factory default configuration (as if &F0 had
been entered) and then changes specific configuration options
for cellular operation as shown in Table D-3.
&F5
Cellular Setting
–16 dBm
120 seconds
Short train
Issue 3 April 1994
AT Command
Equivalent
S91=1
&I16
S7=120
S43=1
t
box, then
D-5