Paradyne Hotwire 7974 Installation Instructions Manual page 31

Table 18 lists Switchpack S2 definitions.
Table 18. Switchpack S2 Definitions (Models 7976 and 7986)
Switch # . . .
1
2
3, 4, 5
6, 7
8
Allows you to . . .
Control whether the unit is an LTU or an NTU.
OFF = NTU
ON = LTU
Control enabling and disabling of the AutoRate capability. Only valid
for units configured as LTU.
OFF = Fixed Rate
ON = AutoRate Enabled
Select one of eight preset DSL line rates (refer to Table 19). If
AutoRate is enabled, DSL Line Rate represents the AutoRate
ceiling.
All OFF = 2064
Not used
Emergency Use Only – The unit has two banks of flash memory
used to hold executable firmware. This switch allows you to change
between the two versions of firmware. This switch is independent
from the position of Switch 1 on Switchpack S1 (switchpack
enable/disable).
OFF = Current Firmware
ON = Previous Firmware
31
Default in Bold