Paradyne Hotwire 7974 Installation Instructions Manual page 29

Table 16 lists Switchpack S2 definitions.
Table 16. Switchpack S2 Definitions (Models 7975 and 7985)
Switch # . . .
1
2
3, 4, 5
6
7
8
Allows you to . . .
Control whether the unit is an LTU or an NTU.
OFF = NTU
ON = LTU
Control enabling and disabling of the AutoRate capability.
OFF = AutoRate Enabled
ON = AutoRate Disabled
Select one of eight preset DSL line rates (refer to Table 19). If
AutoRate is enabled, DSL Line Rate represents the AutoRate
ceiling.
All OFF = 2064 (1040 for 1 Mbps units )
Control enabling and disabling of the Elastic Store feature.
OFF = Elastic Store Enabled
ON = Elastic Store Disabled
Not used
Emergency Use Only – The unit has two banks of flash memory
used to hold executable firmware. This switch allows you to change
between the two versions of firmware. This switch is independent
from the position of Switch 1 on Switchpack S1 (switchpack
enable/disable).
OFF = Current Firmware
ON = Previous Firmware
29
Default in Bold