Advertisement
MIRROR MOUNT
STEP 1
Placment
Select the desired position of the mirror.
Level and mark the location.
[350mm]
STEP 3
Install screws
Using a drill,make holes and fill with supplied
plugsand screws.Leave a gap of 2 - 3mm
between thehead of the screw and the wall.
Φ6mm Drill Bit
M4 PA screws
5
STEP 2
Support location
Measure the center of the holes and mark the
drilling locations ensure marking are leveled.
STEP 4
Placement
Place the mirror against the wall and slide
down as shown in image.
FAUCET INSTALLATION
For first time install, flush the pipes first byopen the angel valve to run 60s.
STEP 1
Clean and wipe the countertop and check if it is
level.
STEP 3
Put the rubber O-ring into the bottom gap offaucets
then Insert faucet into faucet hole.
STEP 5
Adjust position of faucet body if necessary,
Then tighten the mounting nuts with phillips
screwdriver until snug.
STEP 2
Remove the mounting hardware from
themounting pipe.
STEP 4
Slide rubber washer,metal washer and
mounting bracket onto the thread shank.
STEP 6
Connect and tighten the supply hoses by using
twoadjustable wrenches ,Turnon the angle
valve and check for leaks.
6
Advertisement
