Table of Contents
Advertisement
Electrical connection
Details on mains voltage, type of current and the fuses
required should be taken from the rating plate. The rating
plate is fitted near the loading aperture (see "Product de-
scription" chapter).
Connect the machine to an earthed socket, in accordance
with current wiring regulations.
Warning! The manufacturer declines any
responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be
replaced, this must be carried out by an authorised service
engineer or a qualified electrician. .
The appliance is supplied with a 13 amp plug fitted. In the
event of having to change the fuse in the plug supplied,
a 13 amp ASTA approved BS 1363/A fuse must be used.
4
1
The wires in the mains lead are coloured in accordance
with the following code:
1
Blue - Neutral
2
cord clamp
3
Brown - Live
4
Green and Yellow - Earth
The wire coloured green and yellow must be connected
to the terminal marked with the letter «E» or by the earth
symbol
or coloured green and yellow.
The wire coloured blue must be connected to the terminal
«N» or coloured black.
The wire coloured brown must be connected to the ter-
minal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
6
3
2
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Warning! The plug must be accessible after
installing the machine.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
of 3 mm between the switch contacts and of a type suitable
for the required load in compliance with the current elec-
trical regulations.
The switch must not break the yellow and green earth
cable at any point.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed.
Warning! The door must only be reversed by an
authorised service engineer.
Please contact your local Service Force Centre. The en-
gineer will carry out the door reversal at your cost.
Special accessories
• stack kit
Available from your Service Force Centre or your
specialist dealer
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
• drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensate into a
basin, siphon, gully, etc. The condensate tank then no
longer has to be drained, it must however remain in its
intended position in the machine.
Read carefully the instructions supplied with the kit.
Advertisement
Table of Contents
