5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for
dryers. The special bulb can be obtained from your local
service centre.
Important! When the appliance is switched on, the interior
lighting switches itself off after 4 minutes when the door
is open.
Warning! Do not use standard bulbs! These develop
too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with
a permanent connection: fully unscrew or deactivate the
fuse.
Technical data
Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-drained at 1000
2)
rpm)
Average annual energy consumption
Use
Permissible ambient temperature
The consumption values have been established under standard conditions. They may deviate when the machine is
Programme
Parameter
1)
operated in domestic circumstances.
Drying cycle complete
1. Unscrew cover above the bulb (this can be found di-
rectly behind the loading aperture, at the top; refer to
"Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before
screwing back the door light cover. Do not operate the
dryer when missing o-ring gasket on door light cover.
Warning! For safety reasons, the cover must be
screwed down tightly. If this is not done, the dryer
must not be operated.
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 40 kg
max. 7 kg
230 V
10 A
2350 W
B
3.92 kWh
284.1 kWh
Domestic
+ 5°C to + 35°C
Consumption values
Energy consumption in kWh / average drying time in min.
section).
Value
15
Need help?
Do you have a question about the ZDC 77570W and is the answer not in the manual?
Questions and answers