Advertisement
TROUBLESHOOTING
repair work.
Common to LD and CD
=
Reference
|
Symptom
Possible Causes
Page
Operation
1. The disc comes out even when the | @
The disc is dirty or warped.
s
p.7
disc table is closed.
e@ The disc is not placed properly on the disc table.
p.6
@
Condensation formed inside the player.
p.5
2. The player pauses automatically.
® The SINGLE PLAY button is pressed to on.
p. 15
Remote
3. Remote
control
operation
is not | @ The control input jacks are in use.
p.8,9
control
possible.
@ The remote control unit is too far from the player.
p. 12
®@ The batteries are exhausted.
p. 12
4. Improper operation of TV set, etc., | @
Improper operation may occur with some TV sets,
occurs.
Audio
5. Audio is not output or distorted.
® Theconnection between the player andamplifier is erroneous or | p. 8,9
the plugs are not inserted fully into the jacks.
@
The connection plug of the jack is dirty.
@ The player is in pause mode.
p. 13
@ Awrong input is selected on the amplifier.
=> Refer to the operating instructions of the amplifier.
®
The audio output is connected to the PHONO input jacks of the | p. 8,9
amplifier.
LD
i
ae Ra
eee ee ee
eee
lara
Operation
6. Chinese characters appear on the | @ Turn the power
off and unplug the AC power cord. Then, plug the
screen.
AC power cord back in and turn the power on again.
Video.
7. TV programs cannot be viewed.
® The input selector of the TV is not set properly.
picture.
quality
8. Thevideocannotbe viewed, thepicture | @ The disc is dirty or warped.
p.7
quality is poor or noise interferes with | @ The power of the TV is turned off.
the video.
@ The attenuator switch is set to off.
e
The connection is erroneous or the plugs are not inserted fully | P. 8. 9
into the jacks.
9. Apart of the still frame image shakes.
| @ The still frame image may shake if it shows a dynamic scene.
| P. 21
+
——
|
Audio
10.Audio sound is undulating.
@ Adisc which does not carry the CX mark is played while the CX | p. 20
system is ON.
11.Audio is not output.
@
The player is in the still frame or frame-by-frame advance mode. | P. 21
Skip search
12.Skip,
programming
and
search | @
The disc does not contain chapter number information. (The | P. 21, 22
operations do not function properly.
functions utilizing the chapter numbers cannot be used in this
case.)
13.The search takes a long time (more | @ Some discs require much time for readout of data.
than 40 seconds).
14. The start takes time.
@
Some discs tend to cause subcode readout error. (This is not a
malfunction.)
=> Try pressing the stop and play buttons repeatedly to stop and
restart playback. This repetition may sometimes make normal
playback possible.
18.A different time number than specified | @ Some discs tend to cause subcode readout error. (This is nota
is searched.
malfunction.)
25
<VRE1048>
En
|
|
|
|
|
|
Advertisement
