Dte Connection; Dial-Line Connection; Telephone Connection - Paradyne 3825Plus Quick Reference Manual

DTE Connection

Use the following procedure to connect the RS-232-E cable from the modem to the
DTE:
Procedure
1. Make sure the modem's rear panel power switch is Off.
2. Connect the DB-25-P plug on the cable to the DB-25-S socket labeled
COMPUTER on the modem's rear panel. Use a small screwdriver to fasten the
cable to the modem.
3. Connect the other end of the cable to the serial connector on the DTE. Use a small
screwdriver to fasten the cable to the DTE.

Dial-Line Connection

Use the following procedure to connect a 3825 Plus to the dial network interface.
Procedure
1. Insert the 6-position, 4-conductor modular plug into the jack labeled LINE.
2. Insert the other end of the modular cord into the dial network interface.
2-Wire Leased-Line Connection
Use the following procedure to connect a 3825 Plus modem to the 6-pin, center pair,
leased-line network interface. A description of the JM8 to RJ11C crossover cable
required can be found in the user's guide.
Procedure
1. Insert the 6-position, 4-conductor modular plug into the jack labeled LINE.
2. Insert the other end of the modular cord into the leased-line network interface.

Telephone Connection

Use the following procedure to connect the modem to a single-line or two-line
telephone:
Procedure
1. Insert the 6-position, 4-conductor modular plug into the jack labeled PHONE.
2. Insert the other end of the modular cord into the telephone.
3