Paradyne 3825Plus Quick Reference Manual page 14

S-REGISTERS (continued)
Register Description
S56 Remote Access Password
1st and 2nd digits
S57 Remote Access Password
3rd and 4th digits
S58 Remote Access Password
5th and 6th digits
S59 Remote Access Password
7th and 8th digits
S62 V.25bis Coding
S63 V.25bis Idle Character
S64 V.25bis New Line Character
S65 Line Current Disconnect
S66 NMS Call Messages
S67 Directory Location 1 Callback
S68 Answer Security
S69 Make Busy Via DTR
S70 Originate Security
S74 Network Position
S75 Network Management Address
S76 Dial Autorate
S77 DTR Alarm Reporting
S78 Dial Automode
S80 No Data Disc Trigger Signal
S82 Leased Autorate
S84 AT Command Mode
S85 Fast Disconnect
S88 Straps When Disconnected
S89 V.42 ARQ Window Size Increase
S90 DTE Rate = VF Rate
S91 Cellular Enhancement (if ETC installed) 0
S93 RJ11 Cellular Adapt (if ETC installed)
S94 Entry Wait Time
S95 VF Prompt Type
S96 DTE Password Entry Attempt Limit
S97 DTE Password Termination Character 13
S98 DTE Password Backspace Character 08
Factory Setting Range
00 00–99
00 00–99
00 00–99
00 00–99
0 0=ASCII; 1=EBCDIC
0 0=Mark; 1=Flag
0 0=CR+LF; 1=CR; 2=LF
0 0=Enable (8 msec); 1=Enable (90 msec);
2=Disable
0 0=Call Connect & Progress; 1=Disable;
2=Call Connect Only; 3=Call Progress Only
0 0=Disable; 1=Enable
0 0=None; 1=DTE Only; 2=VF and DTE;
3=VF with DTE
0 0=Disable; 1=Enable
0 0=Disable, 1=Enable
0 0=Tributary; 1=Control
255 0–255 (001–256)
0 0=Enable; 1=Disable; 2=Start at 4800;
3=Start at 9600
0 0=Disable; 1=Enable
0 0=Enable; 1=Disable; 2=System85
3 0=RX or TX; 1=TX; 2=RX; 3=TX and RX
0 0=Enable; 1=Disable
0 0=Normal; 1=No Error; 2=No Strap or ERROR
0 0=Disable; 1=Enable
0 0=No Change; 1=Reload; 2=Reload, No Change
0 0(6 frames) – 9(15 frames)
0 0=Disable; 1=Enable
0=Disable; 1=Enable
0 0=Disable; 1=Enable
1 0=10 sec; 1=20 sec; 2=40 sec; 3=60 sec
0 0=Second Dial Tone; 1=Quiet Answer
0 0=1 attempt; 1=2; 2=3; 3=4; 4=5
1–47, 58–64, 91–96, 123–127
1–47, 58–64, 91–96, 123–127
12