Paradyne COMSPHERE 3810 User Manual Supplement page 16

COMSPHERE 3800 Series Modems
Leased Line Configuration Options
Leased TX Level: – 15
Nxt 0 – 1 – 2 – 3 – 4 – 5 – 6 – 7 – 8 – 9 – 10 – 11 – 12 – 13 – 14 – 15
Leased Transmit Level. Selects the modem's transmit power level over leased lines. The
transmit output level can be selected in 1 dBm decrements from 0 dBm to –15 dBm.
The factory default is –15 dBm.
AT command is S-register S45 = n , where n is a value from 0 to 15 corresponding from 0
dBm to –15 dBm.
2W SQ Retrain: Disable
Nxt Disable 1 2 3 4 5
2-Wire Leased Line Signal Quality Retrain. Forces the modem to retrain if the SQ (Signal
Quality) LED is on for more than the specified number of seconds (1–5).
2W SQ Retrain reduces the amount of bad data sent to the DTE when no error control is
used, but greatly increases the likelihood of retrains on impaired lines, especially when
Autorate is disabled.
NOTE: This configuration option is available only if Leased Mode is 2WLL-Orig or
The factory default is Disable.
AT command for 2W SQ Retrain is S-register S81 = n where n is 0 for Disable or 1 to 5
for 1 to 5 seconds.
3-4
Configuration Options for Japan
2WLL-Ans, and affects only V.32 and V.32bis modulations.
September 1998
Table 3-1
(3 of 3)
3810-A2-GB93-30