Kenwood TM-701A Instruction Manual page 22

6. Within 10 seconds of
pressing the MR you should
select the desired transmit
frequency using the tuning
controls or microphone
UP/DWN switches. (For ex-
ample 145.700 MHz)
7. Press the MR key within 10
seconds of selecting the
transmit frequency. A beep
will sound to signal the data
has been successfully
stored.
8. To confirm the contents of
the memory channel press
the MR key. The pro-
grammed receiver frequen-
cy should appear in the
display along with both a
"and "+" offset direc-
tion indicator. This signals
you that this channel has
an odd split entered.
9. To check the transmit fre-
quency press the REV/
STEP key or the PTT key.
The transmit frequency will
appear in the display.
22
am aos ea seer 4
Me
REYSTEP
@ Call Channel
1. Press the VFO key to select
the VFO mode.
2. Select the desired operat-
ing frequency, tone data
etc. (For example 146.100
MHz)
3. Press the F key momentar-
ily. The F indicator will turn
on and the Memory chan-
nel indicator will turn on.
(Channel 8 in the example)
4. Press the CALL key within
10 seconds of pressing the
F key to enter the data into
memory. A long beep will
sound and the F indicator
and memory channel indi-
cators will turn off to con-
firm data entry.
4-4-6. Memory Channel Recall
When recalling a memory channel using this procedure you
will not be able to adjust the frequency or tone data. The
memory channel acts very much like the old crystal con-
trolled radios, i.e. the data is fixed and cannot be changed
by mistake.
1. Press the MR key to select the MR mode. The memory
channel indicator will turn on in the display.
2. Rotate the tuning control or press the microphone
UP/DWN switches to select the desired memory channel.