Kenwood TM-701A Instruction Manual page 11

mately 5 second intervals. If there is activity on the fre-
quency a beep will sound from the speaker. Pressing the
same key sequence again will cancel the function.
Pressing the F key for longer than 1 second and then
pressing the SHIFT/AL key will store the currently dis-
played data as the upper limit for the programmable VFO
tuning limit function.
@) TONE/T.ALT key
Pressing this key by itself causes the radio to select the
desired tone signalling mode. When the ''T"' indicator is
illuminated in the display the transceiver will transmit the
selected subaudible tone. When the ''CTCSS" indicator
is illuminated the transceiver will both transmit the subau-
dible tone and will also remain squelched until the proper
subaudible tone is received.
lf you press the F key momentarily and then press the
TONE/T.ALT key the T.ALT function will be activated.
This function will cause the radio to emit a series of beeps
when an incoming signal is received that will open the
squelch. The function will work with or without the
CTCSS option installed.
TONE frequency selection
Pressing the F key for longer than one second and then
pressing the TONE/T.ALT key will allow you to select the
desired tone frequency. The display will indicate the cur-
rent Tone frequency. To change to a different tone fre-
quency rotate the tuning control or press the UP/DWN
switches on the microphone until the desired tone fre-
quency appears in the display. To return to the normal
frequency display you can press any front panel key ex-
cept the power switch.
@ REV/STEP key
This key is used to reverse the transmit/receive frequen-
cies during repeater operations. If you have selected sim-
plex this key will not function !
Pressing the F key momentarily and then the REV/STEP
key will allow you to select the desired VFO tuning step
and Scan step size. Use the tuning control to select the
desired tuning step and then press any front panel key
except the POWER switch to return to the normal fre-
quency display.
Pressing the F key for longer than 1 second and then
pressing the REV/STEP key will turn the BEEP function
OFF or ON.
@ BAND/DUP key
This key is used to change bands.
Pressing the F key momentarily and then the BAND/DUP
key will cause the duplex function to activate.
11