Kenwood TM-701A Instruction Manual page 16

To select the desired tuning or scan step size use the fol-
lowing procedure:
1. Press the VFO key to select the VFO mode.
2. Press the F key momentarily. The F indicator should light
in the display.
3. Press the REV/STEP key within 10 seconds of pressing
the F key. The current frequency step size will be dis-
played.
4. Rotate the tuning control or press the UP/DWN switches
on the microphone until the desired tuning step size ap-
pears in the display.
5. To complete the programming of the step size you can
press any key on the front panel except the POWER key,
or simply wait 10 seconds and the microprocessor will
automatically return to the normal frequency display.
The chart below shows how the microprocessor will cor-
rect a new step size.
5, 10, 15, 20 to 12.5, 25 12, 5, 25 to 5, 10, 15, 20
Tik cs
10, 12.5 10
20, 25
apie 25 25 20
We rs 37.5 30
50, 55 50 50
60, 65 62.5 60
70, 75 76 70
80, 85 48
90, 95 87.5 80
4-2-4. Programmable VFO tuning limits
The radio provide the capability of programming the VFO
tuning range, in 1 MHz band segments, as well a providing
a separate programmable band scan function (See section
4-5). For example you could tell the transceiver that you only
wish to tune the 144.000 MHz and 145.000 MHz band seg-
ment by specifying any frequency with these two segments.
The tuning controls, microphone UP/DWN switches would
then only tune within these specific bands. The procedure
for specifying the bands is described below.
1. Press the VFO key to select ~~
the VFO mode. ie)
2. Rotate the tuning control
or press the microphone
UP/DWN switches until the
desired lower tuning range
appears in the frequency
display.
For example you might winataat
want to. select the For longer
144 MHz band, and dial up ghient escond
144.100 MHz.
3. Press the F key for longer
than 1 second. The F indi-
cator should begin flashing.
Flashing