Sanyo HTD-5201 Instruction Manual page 17

If you have followed the instructions and are having difficulty operation the unit, locate the SYMPTOM in the left column below. Check the corresponding
POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem.
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
No picture.
The wrong function is selected.
Select the correct function.
No disc is loaded or an unplayable disc is loaded.
Load a disc or load a playable disc. (Check the disc
logo, type, colour system and regional code.)
The TV is not set to receive signal from the unit.
Select the correct input function on the TV.
No sound.
The wrong function is selected.
Select the correct function.
Volume control is set to minimum.
Turn up the volume.
The playback picture is poor.
An unplayable disc is loaded.
Load a playable disc. (Check the disc logo, type,
colour system and regional code.)
" Q " appears on the TV screen.
The selected function does not operate on the disc
now.
The feature or action cannot be completed at this time
because:
- The feature is not available at the moment.
The DVD software restricts it.
The DVD software does not support the feature
(e.g., angles).
The player does not Start play.
No disc is loaded.
Load a disc.
An unplayable disc is loaded.
Load a playable disc. (Check the disc logo, type,
colour system and regional code.)
The disc is loaded with the label side down.
Load the disc on the disc tray correctly.
The disc is dirty.
Clean the disc or replace it.
"PARENTAL" is set.
Cancel the parental lock function or change the
rating level. Reset it after play.
The operation or display is not normal. The memory must be reset.
1. Disconnect the mains lead.
2. Reconnect the mains lead.
3. Resume operation.
The remote control does not work
properly.
The batteries in the remote control are weak, or
installed incorrectly.
Check the battery polarity (+ or -).
Replace the batteries.
The remote control is not aimed at the remote
sensor window.
Aim the remote control at the remote sensor
window.