Paradyne Comsphere 3510 User Manual page 49

Connecting to a V.35 Interface
To connect a V.35 interface cable:
"
Procedure
1. Connect the 25-pin end of the V.35 adapter plug to
the bottom DTE connector on the rear connector
plate (refer to Figure 4-5). Tighten the screws on
both sides of the connector.
In applications where the screws of the V.35
adapter plug might be difficult to fasten because of
conflict with other connectors, use instead a V.35
adapter cable (Feature Number 3000-F1-510).
2. Connect the 34-pin end of the V.35 adapter to the
DTE's V.35 interface cable. Tighten the screws on
both sides of the connector.
Figure 4-5. Model 3511 DSU V.35 Adapter Plug Installation
3510-A2-GN32-70
Installation of the V.35 interface cable is complete.
25-Pin Connector
Thumbscrews
V.35 Adapter
July 1999
NOTE
For the V.35 connector, the
recommended maximum distance
between a DTE and a DSU is
nominally 1000 feet. For the
EIA-232 connector, the effective
shunt capacitance of the circuit,
measured at the DSU, including
the capacitance of the cable and
the DTE, must not exceed
2500 picofarads, as specified
in EIA-232-D.
V.35 Cable
99-16298
Installation
4-9