Table of Contents
Advertisement
Network Dome Camera·Quick Start Guide
● The power source should meet limited power source or PS2
requirements according to IEC 60950-1 or IEC 62368-1 standard.
● Do not connect several devices to one power adapter as adapter
overload may cause over-heating or a fire hazard.
● To avoid fire danger caused by electrostatic charge, never touch
or wipe the camera in explosive environment. Perform the
wiping and replacing accessories only under non-explosive
environment with the provided glove.
● When the camera is installed on wall or ceiling, the device shall
be firmly fixed.
● If smoke, odors or noise rise from the camera, turn off the
power at once and unplug the power cable, and then contact
the service center.
● If the camera does not work properly, contact your dealer or the
nearest service center. Never attempt to disassemble the speed
dome yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)
● Make sure the power supply voltage is correct before using the
camera.
● Do not drop the camera or subject it to physical shock.
● To ensure explosion-proof performance, do not damage
explosion-proof surface.
● Do not touch sensor modules with fingers. If cleaning is
necessary, use clean cloth with a bit of ethanol and wipe it
9
Advertisement
Table of Contents
