Environment
・
・
・Take care that the sensor does not come in direct contact with water, oil,
・
terminal of the equipment to an actual ground.
・Take care that stress is not directly applied to the cable joint.
・This sensor is for indoor use only.
Compatibility
・In case the sensor head is broken, the sensor head replacement is possible
with same model.
required)
Intended Products for CE Marking
・
・Contact for CE
Panasonic Marketing Europe GmbH Panasonic Testing Center
Winsbergring 15, 22525 Hamburg,Germany
Conditions
Operating Conditions for Compliance with CE
・
harmonized standard with regard to immunity that applies to this product is
EN 61000-6-2 (Note) and the following conditions must be met to conform to
that standard.
・The controller must be connected within 10m of the power supply.
・The Signal cable connected to the controller must be shorter than 30m.
・
connector of the cable (GP-XBCC3) for the BCD output unit.
Miscellaneous
・
Ramco Innovations www.ramcoi.com
GP-X series.
Phone 800-280-6933 nsales@ramcoi.com
3