Display Hold; Max / Min / Avg Display; Show Current Temperature - VOLTCRAFT AN-80 Operating Instructions Manual

Preconditions:
a
The power is switched ON.
1. Enter hold mode. See section: Display hold.
2. Short press the
à
The "
3. Auto shut-off will reactivate after the power is switched OFF.

8.3 Display hold

Important:
– The display hold function freezes the display.
– The display hold should be switched OFF before taking measurements.
■
Press the HOLD button to switch display hold ON/OFF.
■
The "

8.4 MAX / MIN / AVG display

In this mode the display shows the "MIN" (minimum), "MAX" (maximum), or "AVG"
(average) values measured.
■
Press the MAX MIN AVG button repeatedly to toggle through modes: MAX →
MIN → AVG.
■
The display will show "MAX", "MIN", or "AVG" to indicate which mode is active.

8.5 Show current temperature

1. Press the UNITS button until a temperature unit shows on the display: °C" or
"°F".
2. Press and hold the UNITS button to change the unit.
à
The display will show the active unit.
button to toggle auto shut-off ON/OFF.
" symbol will disappear when disabled.
"symbol will appear when display hold is ON.
23