Controller Wiring Diagram; Cable Hook Stopper Installation And Use - KFI SE45w-R2 Operator's Manual

Synthetic cable utv/sxs winch

Table of Contents

MODEL #SE45w-R2 – 4,500LB (2041KG) WINCH

Controller Wiring Diagram

#ATV-HR

Handheld Corded Remote

#ATV-CONT or

#AS-CONT

Contactor Block

NOTE: WHITE WIRE MUST

BE CONNECTED TO NEGATIVE

(TYPICALLY BLACK POST) or

VEHICLE GROUND.

Release winch and pull out approximately 2 feet of cable.

Assemble cable hook stopper as shown in diagram with the flat

portion of the two halves resting against your fairlead. Tighten

fasteners.

To stow hook, engage clutch and retract cable onto winch spool

until hook is snug against the hook stopper and fairlead.

Position cable hook stopper at approx. 3/4 of the total

line distance towards the hook while using your

winch to help reduce whip back in the event

of cable breakage.

#ATV-HR

Remote Socket

#UTV-DRS-K

Dash Rocker Switch

ASSEMBLy

IGNITION FED WIRE -

VOLTAGE MUST ONLY BE

SUPPLIED WHEN THE

KEY IS TURNED ON.

+12VDC

Table of Contents

Stealth series