Electrolux WA SL2 EEV201 User Manual page 22

22 electrolux
Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
The drum is empty and
the display shows
there is some weight in
(J).
The drum is full but the
display shows 0.0 kg
(J).
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
Possible cause
Blow out fuse in the household
fuse box.
You did not press button
The delay start is set.
The Child Lock function is acti-
vated.
Leakages from the couplings
of the water hoses.
Leakages from the drain
pump.
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
Incorrect temperature was set.
Too much laundry load.
It is necessary to set a tare.
You loaded the laundry before
to activate the appliance.
Possible solution
Replace the fuse.
4 4
. Press button
To start immediately the programme,
cancel the delay start.
Deactivate the Child Lock function.
Make sure that the couplings are tight.
Make sure that the drain pump filter is
tight.
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
1
Press button
ance and to activate it again.
1
Press button
ance. Empty the drum and obey to the
necessary steps. (Refer to 'Loading the
laundry')
.
to deactivate the appli-
to deactivate the appli-