Table of Contents
Advertisement
LIGHTING THE BURNERS
To
ignite
the
instructions are to be followed:
1.
Press in the corresponding knob and
turn counter-clockwise (fig. 2.2) to the
full flame position marked by the "
symbol (fig. 2.1); hold the knob in until
the flame has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2.
Wait for a few seconds after the gas
burner has been lit before letting go of
the knob (valve activation delay).
3.
Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed "
" position, wait for at least
1 minute and then repeat the lighting
procedure.
Note: If your local gas supply makes it
difficult to light the burner with the knob set
to maximum, set the knob to minimum and
repeat the operation.
26
26
burner,
the
following
Fig. 2.2
"
Advertisement
Table of Contents
