Table of Contents
Advertisement
SECTION OF THE SUPPLY CABLE
TYPE "H05V2V2-F"
resistant to temperatures of 90°C
220-240 V
50-60 Hz
(*)
Connection possible with plug and outlet
(**)
Connection with wall box connection.
REPLACING THER POWER SUPPLY CABLE
The operations must be executed by a qualified technician.
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorized service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A" (fig.
3.1).
•
Open the cable gland by unscrewing
screw "F" (fig. 3.2), unscrew the terminal
screws and remove the cable.
•
The new supply cable, of suitable type
and section, must be connected to the
terminal board following the diagram in
fig. 3.3.
•
Close and hook again the terminal
board cover.
NOTE: The earth conductor must be left
about 3 cm longer than the others.
F
20
20
3 x 0,75 mm
(*) (**)
2
A
E
Fig. 3.2
L
1
N (L
)
2
Fig. 3.1
Fig. 3.3
Advertisement
Table of Contents
