Normal Playback - Zenith VCM322 Installation And Operating Manual

NORMAL PLAYBACK

power eject
menu clear
ch/trk
enter
adj adj
tv / vcr sp / slp
ch/trk
stop pause slow rec / itr
rew play ff
cm skip
EZ review
input
PREPARATION
• Turn on the TV.
• Tune the TV to the VCR output channel (CH 3 or 4).
• If a direct VIDEO/AUDIO connection is made between the
VCR and the TV, set the TV's source selector to VIDEO.
NORMAL PLAYBACK
1.
Insert a prerecorded video cassette.
The indicator will light and the VCR will power-up
automatically.
• Make sure that the TIMER indicator in the VCR indicator panel
is not lighted. If it is, press POWER once.
• If a tape without a safety tab is inserted, the VCR will start
playback automatically.
2.
Press PLAY once.
PLAY appears in the VCR indicator panel and TV screen.
• It is not necessary to select the tape speed for playback. It will
be automatically selected by the VCR.
• In playback, the TV/VCR selector switches to VCR mode
automatically.
3.
Press STOP to stop playback.
STOP appears in the VCR indicator panel and on the TV screen.
• If the tape reaches the end before STOP is pressed, the VCR
will automatically stop, rewind, eject, and it will turn itself off.
TRACKING CONTROL
AUTO TRACKING
The automatic tracking function adjusts the picture to remove
snow or streaks.
The AUTO TRACKING function works in the following cases:
• A tape is played back for the first time.
• Tape speed (SP, LP, SLP) changes.
• Streaks or snow appear because of scratches on the tape.
MANUAL TRACKING
If noise appears on the screen during playback, press either
CH/TRK ( D D / E E ) on the remote control or CH (
panel until the noise on the screen is reduced.
• In case of vertical jitter, adjust these controls very carefully.
• Tracking is automatically reset to normal when the tape is
ejected or the power cord is unplugged for more than 3
seconds.
D D / E E ) on the front
21