Tape Counter Memory Feature - Zenith VCM322 Installation And Operating Manual

TAPE COUNTER MEMORY FEATURE

Indicator Panel TV Screen
2:15 AM
CLOCK
0:05:25
COUNTER
REM 1:07
REMAINING TIME
power
eject
menu clear
ch/trk
enter
adj adj
tv / vcr sp / slp
ch/trk
stop pause slow rec / itr
rew play ff
cm skip
EZ review
input
Indicator Panel TV Screen
REM 1:07
34
REAL-TIME COUNTER
Shows length of tape run in hours, minutes, and seconds (refer
to the left). Press ENTER to select the real-time counter display.
Each additional press of ENTER changes the counter display as
shown left.
• Counter changes to 0:00:00 when a cassette is ejected.
• The real-time counter does not operate if nothing is recorded
on the tape.
• The real-time counter only works if a tape is in the VCR.
COUNTER MEMORY FUNCTION
This is useful if there is a section of tape you want to view imme-
diately after recording or if you want to return to the same point
several times.
1.
Begin recording or playing a tape.
2.
Press ENTER repeatedly to display the real-time counter
on the TV screen.
3.
At the point you want to locate later, reset the real-time
counter to 0:00:00 by pressing CLEAR.
4.
Continue to play or record.
5.
Press STOP when recording or playback finishes.
6.
Press REW.
The tape automatically stops when the tape counter returns to
about "0:00:00".
TAPE REMAINING
This function allows the time of the remaining tape to be dis-
played during recording or playback.
Press ENTER repeatedly until the REM indicator appears
during recording or playback.
NOTE
The remaining tape length indicator may not be displayed
correctly depending on the condition and type of tape (T-120,
T-140, or T-160 etc)