Off Air Antenna - Zenith TVBR1322Z Operating Manual

Hook Up an Off Air Antenna
Connect an off air antenna to your Entertainment Machine
1
Hook up your Entertainment Machine,
see diagrams at right.
Remove the back of the remote and
2
put in two AA batteries.
back of
remote
3
Plug in your TV. Do not plug it into a
switched outlet.
120 V AC
60 Hz
4
Go to page 17 to set up Auto Ch
Memory on your Entertainment
Machine.
If you have a 75 ohm RF cable, then
you don't need any adapters!
Remember, when screwing RF cables
onto jacks, clockwise tightens, and
counterclockwise loosens.
A 300 to 75 ohm adapter is not
included with your Zenith
Entertainment Machine.
Mini glossary
75 OHM RF CABLE The wire that comes from an off air antenna or cable service provider. Each end looks like a hex shaped nut with
a wire sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300-75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an
inch long with two screws on one end and a round opening with a wire sticking out on the other end.
206-3481
Antenna
(Indoor or
Outdoor)
Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF coaxial wire
(75 ohm)
VHF
UHF
Typical
TV/VCR back
VHF
UHF
P A G E 9