Table of Contents
Advertisement
4. Volume Board Removal
6.1 Perform step 1.
6.2 Remove the 4 screws that secure the
Volume board as indicated in Figure 15.
6.3 Push the 3 Volume buttons out and lift off
the board.
L1 Pro32 Upper Mid-high Array Procedures
1. Grille Removal
1.1 Remove the 8 screws that secure the
Endcaps from both ends of the Upper Array as
indicated in Figure 16.
1.2 Lift off both endcaps. Figure 17.
Note: Be careful the cable of one of endcaps
is very short.
1.3 Grasp the Grille and carefully slide the
grille off of the baffle. Figure18 (left).
Re-assembly Note: Be sure there is sufficient
gasket material on the Grille to prevent buzzes
as the red arrow indicated in Figure18 (right).
Gasket material PN: 843112-0101
Perform the Array sweep tests after replacing
the Grille.
DISASSEMBLY PROCEDURE
Figbure 15. Volume Board Screws Removal
Figure 16. Both Ends of Endcaps Screws
Figure 17. One Endcap Removal
Figure 18. Array Grille Removal & Gasket
Material Location
37
Removal
Advertisement
Table of Contents
