Table of Contents
Advertisement
DISASSEMBLY PROCEDURE
1.4 Use your hands and lift up on the
Bottom Cover as indicated in Figure 7.
1.5 Once the Bottom Cover is out from the
Top Cover, you will notice that the 2 cables
1 3
2
& the 1 FFC cable
are attaching the
Main-I/O board from Air fan baffle and Pow-
er-Amp Board. Figure 8.
Figure 7. Bottom Cover Removal
Re-assembly Note:
If the Ferrite bead is in the position as indi-
cated in Figure 8 (left), unwrap the adhesive
Ferrite Bead
foam and move it to the position Figure 8
(right) to not get wedged in between the plas-
tic fan housing and any electrolytic capacitors
on the board when reassembling.
2. Main-I/O Board Removal
2.1 Perform procedure 1.
2.2 Remove the green adhesive with IPA
4 5
(Isopropyl alcohol) from the
cables'
Figure 8. Detach Cables Connection & Ferrite
connections with Volume board. Figure 9
Bead Position
3
2.3 Remove the green adhesive
holding the
Bluetooth antenna cable and disconnect the
Bluetooth antenna connector as the red arrow
indicated in Figure 9.
2.4 Remove the 7 screws securing the Main-
I/O board. Figure 9.
2.5 Pull the 3 Volume knobs out. Figure 10
(left).
2.6 The PC sheet top cover are secured with
Figure 9. Main-I/O Board Green Adhesive &
Pressure Sensitive Adhesive - use a spudger,
Screws Removal
lift the Top cover up and grasp and pull them
off. Figure 10 (right).
Note: Use a heat gun, gently heating the
whole top surface moved around the area to
help loose the adhesive.
Re-assembly Note:
Use a new replacement PC sheet top cover to
ensure proper adhesion during reassembly.
Figure 10. Volume Knobs & Top Cover
PN: 843967-0110
Removal
35
Advertisement
Table of Contents
