Table of Contents
Advertisement
Hook Up Over-The-Air Antenna and VCR
Connect your off-air antenna and VCR to the Entertainment Machine
1
Locate the Antenna/Cable (In) jack on the back of
the VCR.
2
Connect the cable that runs from the antenna
directly to this jack, according to one of the dia-
grams shown to the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. The TV is designed to operate on
standard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Current.
120 Volt
60 Hz AC
No A/V cables are included with the Zenith
Entertainment Machine.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
P A G E 1 2
Back of
Remote
Antenna
Flat Wire
(300 ohm)
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
Cable
R Audio L
Y
Video In
R Audio In L
M.P.I.
S-Video Out
S-Video In
R Audio In L
Antenna
RF Coaxial Wire
(75ohm)
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
Cable
R Audio L
Y
Video In
R Audio In L
M.P.I.
S-Video Out
S-Video In
R Audio In L
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Audio
Video
300/75 ohm
Adapter
A/V cables
not included
with TV
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Audio
Video
A/V cables
not included
with TV
206-3686
Advertisement
Table of Contents
