Antenna With Vcr - Zenith B19A23DCOM Operating Manual And Warranty

A
Hook Up Your Antenna and VCR
Connect a VCR to your Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your Entertainment
4
Machine. Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on house-
hold current, 120-volt 60 Hertz
AC do not attempt to operate it
on DC Current.
Go to page 12 to Auto Program
5
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
206-3480
Antenna
Flat wire
(300 ohm)
OUT
R Audio L/Mono
ANT IN
IN
75 Ω

Antenna with VCR

Antenna
RF coaxial wire
(75 ohm)
TV back
OUT
R Audio L/Mono
ANT IN
IN
75 Ω
Flat Wire Antenna with VCR
VCR back AV panel
In
Out
TV back
RF coaxial wire
(75 ohm)
not included
with TV
Video
A/V cables
not included
with TV
VCR back
VCR back AV panel
In
Out
RF coaxial wire
(75 ohm)
not included
with TV
Video A/V cables
not included
with TV
VCR back
output
switch
3 4
Video
Audio
output
switch 3 4
Video
Audio
P A G E 9