Antenna With Vcr - Zenith H27E44DTOM Installation / Operating Manual | Warranty

Hook Up Over-The-Air Antenna and VCR
Connect your off-air antenna and VCR to the Presentation TV
1
Locate the Antenna/Cable (In) jack on the
back of the VCR.
2
Connect the cable that runs from the antenna
directly to this jack, according to one of the
diagrams shown to the right.
3
Remove the back of the remote and put in
two AAA batteries.
back of
remote
4
Plug your TV in to a standard power outlet.
This TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt
to operate it on DC Current.
5
Go to page 14 to Auto Program the
Presentation TV.
No A/V cables are included with the Zenith
Presentation TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
206-3753
Antenna
Flat Wire
(300 ohm)
TV Back
Matrix
Antenna
Out
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
S-Video
R- Audio - L
Out
In
In
Antenna
RF Coaxial Wire
(75ohm)
TV Back
Matrix
Antenna
Out
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
S-Video
R- Audio - L
Out
In
In
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Video Audio
300/75 ohm
Adapter
A/V cables
not included
with TV
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Video Audio
A/V cables
not included
with TV
P A G E 9