Front Panel Controls/Inputs - Zenith Presentation H25E46DT Installation And Operating Manual, Warranty

Front Panel Controls/Source Inputs
Using the front control panel to access the menus
1
To access the menus, press the MENU button
on the control panel. Cycle through the vari-
ous menus by pushing the button repeatedly.
2
Press the SELECT button repeatedly to high-
light the option you want to modify.
3
Press either the Right or left ADJUST button
to modify the selected option.
4
The menu will disappear after a few seconds.
There are three jacks on the front of the Presentation TV
that make connecting Audio/Video devices like camcorders
very simple.
To use the front jacks as the signal source, simply plug a
composite video cable into the VIDEO jack. The TV will
automatically change its source setting to CamPort, as
indicated on the channel selection screen.
Auto Sense source connections override all other
sources. The front Video In jack and the front
Computer In connector are Auto Sense source inputs.
If you have device(s) connected to either of these
jacks, you will not be able to change channels until
you have disconnected the device(s).
ComPort TM and CamPort
Zenith Electronics Corporation
P A G E 2 2
TM are trademarks of
Typical Front Panel Controls
captions adjust select menu
3
2
reset
TM
ComPort
Front
Computer
(Input)
Used for 800 x
600 60Hz SVGA
type computer
hookup.
volume channel
1
video in L audio R
Left/Right Audio (Input)
Connects the audio output from
external stereo audio devices.
TM
CamPort
Front Video
(Input)
Connects the
video output
from external
video devices.
power
206-4543