Cable Service With Vcr; Hook Up Cable Service (Catv) And Vcr - Zenith Presentation H25E46DT Installation And Operating Manual, Warranty

Hook Up Cable Service (CATV) and VCR

Connect a VCR and Cable service to the
Presentation TV
1
Locate the Antenna/Cable In jack on the
back of the VCR.
2
Connect the cable that runs from the
wall, according to one of the diagrams at
the right. Make other connections as
shown.
3
Remove the back of the remote and put
in two AAA batteries.
Back of
Remote
4
Plug in the TV. The Presentation TV is
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC Current.
5 Go to page 21 to Auto Program the
Presentation TV.
Leave the VCR and the television tuned to
channel three and use the cable box to change
channels.
No A/V cables are included with your
Presentation TV. Without A/V cables, most
VCRs will not play videocassettes in stereo
sound.
P A G E 1 8
TV Back
ANTENNA
CABLE
S-VIDEO OUT S-VIDEO IN
COMPUTER
IN
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT
COMPUTER
L
AUDIO
Cable TV
wall jack
In
Out
RF coaxial wire (75ohm)
TV back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN
R- AUDIO- L
COMPUTER
IN
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
Cable TV
Wall Jack
Round wire (75ohm)
A/V cables
not included
R- AUDIO- L with TV
R- AUDIO- L
R- AUDIO- L
Cable box
output
switch 3 4
VCR back AV panel
In
Out
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video Audio
VCR back
output
switch
3 4
Video Audio
206-3602