Air Filter - Coleman POWERSPORTS B100 105cc Owner's Manual

RIDING THE MINI BIKE
STARTING ENGINE
To start the engine
1. Place the fuel valve (1) in the
"ON" (vertical) position.
2 .. If engine is cold, place the choke
lever (2) in the "ON" (right position.
3. Place the ON/OFF switch (3),
located on the handlebars, in the U
(on)position.
4. Pull the starter recoil cord (4) to
start the engine.
5. Once engine has warmed up for a
few minutes, place the choke lever
(2) back to the "OFF" (left) position.
A WARNING
Starting or running the Mini
Bike in an enclosed area
such as a garage or shed
where there is no ventilation
is hazardous.
Inhaling exhaust fumes from
the Mini Bike can cause se-
vere injury or death
Never start or run the Mini
Bike in an enclosed
environment where there is
no ventilation. Always start
and run outdoors.
13
4
MAINTENANCE

Air Filter

The air cleaner element needs to
be cleaned or replaced periodically
(see chart for cleaning/replace-
ment intervals. The air filter
element will need to be cleaned
more often if Mini Bike is ridden in
muddy, wet, or dusty conditions. A
clean air filter will help the Mini Bike
run at peak performance allowing
better gas mileage, more power
and will protect the engine from the
damaging effects of dirt entering the
engine.
Air filter removal,
inspection and cleaning
instructions
1. Locate the air filter assembly (1)
2. Remove the Air filter assembly
cover by removing the air filter
cover knobs (2).
3. Remove the foam element (3).
4. Clean foam element wit mild
soap and water. Rinse and
squeeze out excess water and allow
to dry.
Note: If foam element (3) is
damaged, replace.
18
CAUTION
Clean air filter frequently if
Mini Bike is driven in wet,
muddy or dusty conditions.
Driving in the above condi-
tions without cleaning fre-
quently can plug up the air
filter which can cause poor
gas mileage, low power and
cause damage to the engine.
4