Advertisement
3. Power Connection
12 - 24V DC
Transformer
Power - PAL requires a 12-24V DC transformer. PAL reaches
A
30mA at maximum power consumption.
NOTE: the + and – power inputs can be wired to either power
input on the PAL board, they are interchangeable
Network Connection - The PAL SIM card must be activated before
installation of the PAL Spider. In order for PAL Unit to work properly,
There must be a reliable AT&T Network signal at the location of the PAL
installation.
Signal Level - Once powered on, the PAL will go through an automatic network boot up. After 60-seconds if
working properly the PAL device will have a solid LED light on the Network and one of the signal LED's.
A company account on portal.pal-es.com is required to register the PAL device. If you do not currently have
a company account call us at 866-975-0101. Use your login credentials to login to the PAL home page.
4G
2.4 Ghz
SIM
433 Mhz
4. Network Connection/Account Setup
4G
2.4 Ghz
SIM
433 Mhz
LEDs key
Meaning
Action
Fast flashing of the SIM light
System is booting
Slow flashing of the SIM light
Searching for a cellular network
2 blinks and break
connecting to the Internet process
4 Short flash of the SIM
Connecting to the PAL interface
Sim LED is stable
System ready
Signal light No. 1 is on
Low signal
Signal light No. 2 is on
Good signal
Signal light No. 3 is on
Very good signal
SIM CARD LOCATION
2
Advertisement
