LEDs key
SIM/Network LED
Fast Flashing: System is booting
Slow Flashing: Module is
searching for a cellular network
All LEDs Flashing: SIM card not
recognized
Typical wiring connection to
an Electronic Strike:
Optional
A
Magnetic
Sensor
Installation allows you
to receive a gate
status notification
A
Door or Gate Position switch - Mount this
on the door frame or on the gate in the
desired location with the wire running to the
input on the PAL controller, like shown above.
When using two door or gate position sensors
for double doors wire them in series with one
leg of each switch running back to the
controller for connection.
Typical wiring connection to
a Maglock:
Optional
A
Magnetic
Sensor
Installation allows you
to receive a gate
status notification
SPIDER CONTROLLERS
LED 1
Blinking Twice:
Connecting to the internet
Blinking Four Times:
Connecting to the servers
Signal Strength
Electric Strike
Maximum load
2A/30VDC; 0.5A/125VAC
2480 South 3850 West, Suite B , Salt Lake City, UT 84120
(866) 975-0101 • (866) 975-0404 fax sales@transmittersolutions.com
4G Signal Strength Indicator
LED #1 ON: Low signal
LED #1 and #2 ON: Good signal
LED #1, #2, and #3 ON: Very good signal
4G
2.4 Ghz
SIM
433 Mhz
Input voltage
12VDC / 3A
4G
2.4 Ghz
SIM
433 Mhz
Input voltage
12VDC / 3A
Maglock
Maximum load
2A/30VDC; 0.5A/125VAC
7